API 580 Exam Page2(Dumps)
Question No:-11
|
The models are evaluated _____________ to provide both qualitative and quantitative insights about the level of risk and to identify the design, site, or operational characteristics that are the most important to risk
1. Probabilistically
2. Statistically
3. Linearly
4. Logically
|
Question No:-12
|
Potential source of errors in RBI analysis regarding data quality are the following except
1. If the base line thickness were not performed the nominal thickness may be used for the original thickness
2. If original thickness not available, averaged at thickness readings may be used
3. If the original thickness not available, maximum at thickness readings may be used
Answer:-1. If the base line thickness were not performed the nominal thickness may be used for the original thickness
|
|
Question No:-13
|
Potential source of errors in RBI analysis regarding data quality are the following except
1. Assumptions in equipment history
2. Outdated drawings and documentation
3. Inspector error
4. Advanced inspection methods
Answer:-4. Advanced inspection methods
|
|
Question No:-14
|
The following assumption can be made that significantly impact the calculated corrosion rate early in the equipment life
1. If the base line thickness were not performed the nominal thickness may be used for the original thickness
2. If original thickness not available, averaged at thickness readings may be used
3. If the original thickness not available, maximum at thickness readings may be used
Answer:-1. If the base line thickness were not performed the nominal thickness may be used for the original thickness
|
|
Question No:-15
|
________________ may result in the calculated corrosion rate appearing artificially high or low.
1. Clerical error
2. Measurement error
3. Inspector error
4. At scanning
Answer:-2. Measurement error
|
|
Question No:-16
|
The data validation step stresses the need for a knowledgeable individual.
1. To comparing data from the inspections to the expected deterioration mechanism and rates
2. To compare the results with previous measurements on that system
3. Similar systems at the site or within the company or published data
4. All of the above
Answer:-4. All of the above
|
|
Question No:-17
|
The amount and type of codes and standards used by a facility can have
1. Significant impact on RBI results
2. No impact on RBI results
3. Less significant impact on RBI results
Answer:-1. Significant impact on RBI results
|
|
Question No:-18
|
Who should be consulted to define the equipment deterioration mechanisms, susceptibility and potential failure modes?
1. A metallurgist or corrosion specialist
2. A metallurgist and corrosion specialist
3. A metallurgist only
4. Corrosion specialist only
Answer:-1. A metallurgist or corrosion specialist
|
|
Question No:-19
|
_________ are the primary inputs into the probability of failure evaluation.
1. The deterioration mechanisms, rates and susceptibilities
2. Loss of containment f fluid
3. Fluid toxicity and its concentration
4. Damage mechanisms and its severity
Answer:-1. The deterioration mechanisms, rates and susceptibilities
|
|
Question No:-20
|
Is key to performing deterioration mechanism identification
1. Understanding equipment operation and the interaction with the chemical and mechanical environment
2. Understanding equipment operation and process upsets
3. Understanding equipment operation and its safety protective measures
Answer:-1. Understanding equipment operation and the interaction with the chemical and mechanical environment
|
|
|